GE MDS ORBIT ECR User Manual

456 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
Cisco switch as authenticator 13.2.8
The following configuration was used to evaluate behavior of another authenticator, ensuring the Orbit is
compatible with established devices already being used in industry. A Cisco Catalyst 2960-S switch was
used.
Switch#show configuration
Using 2061 out of 524288 bytes
!
version 12.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
hostname Switch
boot-start-marker
boot-end-marker
enable secret 5 $1$sP31$MR/SumVvQhHlirgeef3gY0
username login privilege 15 nopassword
aaa new-model
aaa authentication dot1x default group radius
aaa authorization network default group radius
aaa authorization network mylist none
aaa session-id common
switch 1 provision ws-c2960s-24ts-l
dot1x system-auth-control
spanning-tree mode pvst
spanning-tree extend system-id
vlan internal allocation policy ascending
interface FastEthernet0
no ip address
interface GigabitEthernet1/0/1
switchport mode access
interface GigabitEthernet1/0/2
switchport mode access
authentication order dot1x
authentication port-control auto
dot1x pae authenticator
interface GigabitEthernet1/0/3
….
interface Vlan1
ip address 192.168.1.100 255.255.0.0
interface Vlan2
no ip address
ip http server
ip http secure-server
radius-server host 192.168.1.200 auth-port 1812 acct-port 1646
radius-server key password
line con 0
line vty 0 4
password cisco
line vty 5 15
password cisco
end
Switch#

GE MDS ORBIT ECR Specifications

General

Brand	GE
Model	MDS ORBIT ECR
Category	Network Router
Language	English