448 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
Windows as 802.1x peer/supplicant – start WiredAutoConfig service 13.2.3
All EAP authentication modes on Windows require the following service to be started before configuring
authentication on a wired network interface. When using EAP, the Orbit ETH port security mode must
also be set to EAP. The Orbit is agnostic to the specific EAP method chosen. Examples in this document
show Cisco PEAP and EAP-TLS methods being used.
Windows configuration #1 - Cisco PEAP mode 13.2.4
Following shows the configuration used to test Cisco PEAP mode on Windows