Genban IP8820 - Page 135

IP8820/IP8830/IP8840
Installer Guide
D-9
Section
Field Name
Description
line1_ring_type~
linen_ring_type
Specifies the ring type for the line. The n variable is the line
button and can be from 1 to the max_line_num. Ring type
can be a value from -1 to 4, 101 to 105, or 201 to 205:
• -1, use default ring type
• 0, ringer off
• 1 ~ 4, ring type 1 to 4 (tone ring),
• 101 ~ 105, ring type 101 to 105 (wav file ring),
• 201 ~ 205, ring type 201 to 205 (user defined ring),
Valid values are -1 or 0 to 4, 101 to 105, and 201 to 205.
The default is -1, default ring type.
line1_delayed_ring~
linen_delayed_ring
Specifies a delay in the audible ring for the line. The n
variable is the line button and can be from 1 to the
max_line_num. Delayed ring is adjustable from 0 to 10
seconds in 1-second increments
Valid values are 0 to 10 seconds.
The default is 0.
Defines a dial plan using a Routing Table. This parameter adds entries to the
table. If a dialed number matches an entry, the number is modified and the
call processed. An entry may include 0 to 9, ‘*’ and ‘#’ and the following
special characters.
‘~’ a wild card character that matches any multiple characters.
‘?’ any dialed digit.
‘.’ represents “virtual dial tone”
‘,’ locates the position of a 3-second pause in the prefix number.
Valid values are up to 50 entries with below information.
The default is blank.
intf
Must be “SIP”.
port
Must be “0”.
nums
Sets the digit pattern for a match.
The valid value is a sequence of digits 0 to 9, ‘*’, ‘#’, ‘~’, ‘?’, ‘.’
or NULL up to 31 digits.
trunc
Specifies the number of digits to be stripped before further
processing.
Valid values are 0 to 31.
pre
Specifies digits to add in front of the truncated number.
Valid values are 0 to 9, ‘*’, ‘#’, ‘.’, ‘~’ or NULL up to 31 digits.
post
Specifies the number to add at the back of the truncated
number.
Valid values are 0 to 9, ‘*’, ‘#’, ‘.’, ‘~’ or NULL up to 31 digits.
pause
Locates the position of a 3 seconds pause before processing
the number. A ‘,’ locates the pause in the entry.
Valid values are ‘?’, ‘,’ or NULL up to 103 digits.
ROUTE
add
ip-addr
Specifies an IP address as the destination when a match
occurs without regard to the proxy address.
The valid value is an IP address
handsfree
Specifies the gain level for the phone’s handsfree speaker.
Valid values are 1 through 11.
The default is 6.
DSP
handset
Specifies the gain level for the phone’s handset.
Valid values are 1 through 11.
The default is 6.