EasyManua.ls Logo

Genban IP8820 - Page 141

Genban IP8820
158 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP8820/IP8830/IP8840
Installer Guide
D-15
Section
Field Name
Description
call_direct
Controls Hotline/Warm-Line operation. Going off-hook
automatically places a call to the designated party.
Valid values are enable or disable.
Default is disable.
call_direct_number
Defines the destination for a direct call.
Valid value is extension number up to 50 characters.
The default is blank.
call_direct_timer
Sets the delay for Warm Line operation. After the timer
expires, the direct call is made. Set to zero (0) for Hotline.
Valid values are 0 to 10 seconds delay.
Default is 5.
send_end_of_digit
Determines if the IP Phone sends the end of digit mark ‘#’.
Valid values are enable or disable.
The default is enable.
phone_name
Assigns a name to the phone for idle mode display.
Valid value is a string of up to 15 characters.
The default is blank.
lang
Specifies the language displayed on the LCD. Support for a
given language is limited by the LCD type.
Valid values are:
English_Default
French_France
Korean_Korea
Danish_Denmark
Spanish_Spain
Swedish_Sweden
German_Germany
Chinese_China
Default is 0 (English).
lock_outgoing_call
Unlocks the phone so a password is not required to place an
outgoing call.
Valid values are 0 to unlock or 1 to lock.
Default is 0 (unlock).
use_speed_number
Assigns use of 2-digit Speed number dialing.
Valid values are 0 to disable or 1 to enable.
Default is 1 (enable).
web_server_port
Assign the port used to access the IP Phone Web manager.
Valid value is 1 ~ 65535.
The default value is 8000.
web_server
Enables access to the Web Manager.
Valid values are 0 to disable or 1 to enable.
Default is 1 enable.
telnet_server
Enables access to the telnet server.
Valid values are 0 to disable or 1 to enable.
Default is 1 enable.
phone_password
Assigns password for LCD Configuration Menu and Phone
Unlock.
Valid value is a digit string up to 8 digits.
Default is blank.
SYSTEM
function cdp
Enables cdp on reboot to define VLAN.
Valid values are enable or disable.
Default is enable.

Table of Contents