9.4 Message Reference
145
99
Sets and queries the Standard Event Status Enable Register (SESER)
Syntax
(Command)
∗ESE <0 to 255 (NR1)>
The SESER mask is set to the numerical value 0 to 255. The numeri-
cal value can be in NRf format, but any digits after the decimal point
will be rounded.
The initial value (at power-on) is 0.
(Query)
∗ESE?
The contents of the SESER, as set by the *ESE command, are
returned as an NR1 value (0 to 255).
(Response)
<0 to 255 (NR1)>
Example
(Command)
∗ESE 36
Sets bits 5 and 2 of SESER.
(Query)
∗ESE?
(Response)
36
SESER bits 5 and 2 have been set.
Error
Execution error appears when setting is carried out in a format different from the
NR1 numeric value format.
Note
A header is not added to the response message.
128643216 8 4 2 1
bit 7bit 6bit 5bit 4bit 3bit 2bit 1bit 0
PON unused CME EXE DDE QYE unused unused
To Next Page
Loading...
