Hioki 3174 - Page 186

9.4 Message Reference
180
Sets and Queries the data terminator for response messages
Syntax
(Command)
:TRANsmit:TERMinator <0 to 1 (NR1)>
Sets the data terminator for response messages.
When powering on, the data is initially set to 0 (LF+EOI).
(Query)
:TRANsmit:TERMinator?
Returns the data terminator for response messages as a numerical
value (0 or 1) in NR1 format.
(Response)
<0 to 1 (NR1)>
0....... LF+EOI
1....... CR, LF+EOI
Example
(Command)
:TRANsmit:TERMinator 0
Sets the terminator for the response message to LF + EOI.
(Query)
:TRANsmit:TERMinator?
(Response)
0
Data terminator has been set to LF+EOI.
Cancel remote
Syntax
(Command)
:SYStem:LOCAl
The remote state is canceled, and the system goes into the local
state.
Error
The execution of this command in a state other than the remote state causes an
execution error.
Initialize to the default factory settings
Syntax
(Command)
:SYStem:RESet
This resets the settings to the default factory settings.
After initialization, the screen returns to the initial screen.
Note
• Send the ∗RST command if initialization of saved data is not required.
• For items to be initialized, refer to "11.4 System Reset" (p. 198)