Hioki 3174 - Page 185

9.4 Message Reference
179
99
Sets and Queries status out
Syntax
(Command)
:SYStem:STATus <H.V.ON>,<TEST>,<PASS>,<FAIL>,
<INT.LOCK>,<READY>,<EXT.CONT.>,<POWER.ON>
Sets the contents for status out.
(Query)
:SYStem:STATus?
Queries the contents for status out.
(Response)
<H.V.ON>,<TEST>,<PASS>,<FAIL>,<INT.LOCK>,<READY>,<EXT.C
ONT.>,<POWER.ON>
Contents for status out......... 0/1 (NR1)
0: Not set
1: Set
Example
(Command)
:SYStem:STATus 1,1,0,0,0,0,0,0
Set the contents for status out as follows.
H.V.ON: Set, TEST: Set,
PASS: Not set, FAIL: Not set,
INT.LOCK: Not set, READY: Not set,
EXT.CONT.0: Not set, POWER.ON: Not set
(Query)
:SYStem:STATus?
(Response)
1,1,0,0,0,0,0,0
The contents for status out are as follows.
H.V.ON: Set, TEST: Set,
PASS: Not set, FAIL: Not set,
INT.LOCK: Not set, READY: Not set,
EXT.CONT.0: Not set, POWER.ON: Not set