HOEFLON C30e - Page 155

10.3 Error codes - 20240206
Error code Description / comment Correction procedure
95 Stable-on-ground sensor invalid outrigger rear
right
96 Outrigger BR extension sensor invalid 1. Make sure that the system voltage is
nominal
2. Do a check of the sensor connection.
3. Do a check of the cable.
99 Outrigger BL angle sensor invalid 1. Make sure that the system voltage is
nominal
2. Do a check of the sensor connection.
3. Do a check of the cable.
102 Stable-on-ground sensor invalid outrigger rear
left
103 Outrigger BL extension sensor invalid 1. Make sure that the system voltage is
nominal
2. Do a check of the sensor connection.
3. Do a check of the cable.
106 Jib3 angle sensor invalid
108 Jib3 extension sensor invalid
110 Boom angle sensor invalid 1. Make sure that the system voltage is
nominal
2. Do a check of the sensor connection.
3. Do a check of the cable.
112 Boom extension sensor invalid 1. Make sure that the system voltage is
nominal
2. Do a check of the sensor connection.
3. Do a check of the cable.
113 Pressure sensor lift cylinder base invalid 1. Make sure that the system voltage is
nominal
2. Do a check of the sensor connection.
3. Do a check of the cable.
114 Lift cylinder rod pressure sensor invalid 1. Make sure that the system voltage is
nominal
2. Do a check of the sensor connection.
3. Do a check of the cable.
120 Slewing ring rotation sensor invalid
132 Ballast present sensor invalid Do a check of the sensor connection.
133 Ballast extension sensor invalid Do a check of the sensor connection.
136 Boom winch pressure sensor invalid
137 Pressure sensor winch boom low
138 Pressure sensor winch boom high The load is too heavy. Reduce the load.
User guide - C30e Compact crane 143