10.3 Error codes - 20240206
Error code Description / comment Correction procedure
225 Outrigger front right recalibration required Recalibrate the sensor:
1. Fully extend the outrigger leg,
2. Fully retract the outrigger leg,
3. Do a check to see if the calibration is
correct.
226 Outrigger rear right backup mode sensor A
227 Outrigger rear right backup mode sensor B
228 Outrigger rear right recalibration required Recalibrate the sensor:
1. Fully extend the outrigger leg,
2. Fully retract the outrigger leg,
3. Do a check to see if the calibration is
correct.
229 Outrigger rear left backup mode sensor A
230 Outrigger rear left backup mode sensor B
231 Outrigger rear left recalibration required Recalibrate the sensor:
1. Fully extend the outrigger leg,
2. Fully retract the outrigger leg,
3. Do a check to see if the calibration is
correct.
232 Boom extension sensor: backup mode sensor A
233 Boom extension sensor: backup mode sensor B
234 Boom extension sensor: recalibration required
235 Ballast extension sensor: backup mode sensor A
236 Ballast extension sensor: backup mode sensor B
237 Ballast extension sensor: recalibration required
238 Jib3 extension sensor: backup mode sensor A
239 Jib3 extension sensor: backup mode sensor B
240 Jib3 extension sensor: recalibration required
250 RCL invalid (probably because 1 of the inputs is
invalid)
User guide - C30e Compact crane 145
To Next Page
Loading...