54
Usage guidelines
A network ID is only locally significant. You can configure different NHRP network IDs for different
tunnel interfaces on the device. The NHC and server can have different NHRP network IDs.
If you execute this command multiple times, the most recent configuration takes effect.
Examples
# Set the NHRP network ID to 10 for mGRE tunnel interface Tunnel1.
<Sysname> system-view
[Sysname] interface tunnel 1 mode mgre
[Sysname-Tunnel1] nhrp network-id 10
Related commands
interface tunnel (Layer 3—IP Services Command Reference)
New command: nhrp nhs
Use nhrp nhs to configure an NHS private-to-public address mapping.
Use undo nhrp nhs to delete an NHS private-to-public address mapping.
Syntax
nhrp nhs nhs-address nbma nbma-address
undo nhrp nhs nhs-address nbma nbma-address
Default
No NHS private-to-public address mappings are configured.
Views
mGRE tunnel interface view
Predefined user roles
network-admin
Parameters
nhs-address: Specifies the private address of an NHS.
nbma-address: Specifies the public address (NBMA address) of the NHS.
Usage guidelines
You can configure multiple NHSs for redundancy. If multiple NHSs are configured, NHCs register
with all the NHSs.
Examples
# On interface Tunnel1, configure the NHS private address as 1.1.1.1 and public address as
120.1.1.120.
<Sysname> system-view
[Sysname] interface tunnel 1 mode mgre
[Sysname-Tunnel1] nhrp nhs 1.1.1.1 nbma 120.1.1.120
To Next Page
Loading...
Need help?
General
