233
New feature: Support of Syslog for DNS and support of
customlog&userlog for IPv6 hosts
Configuring Support of Syslog for DNS and support of
customlog&userlog for IPv6 hosts
The two flow log export destinations (information center and log host) are mutually exclusive. Only
one export destination can be used at a time. If you configure both export destinations, the flow logs
are exported to the information center and are not exported to the log host.
Command reference
See HPE FlexNetwork MSR Configuration Guides(V7) and HPE FlexNetwork MSR Command
References(V7).
New feature: QoS soft forwarding
Configuring QoS soft forwarding
Configuring PQ: You can define a set of assignment rules in a PQ list and then apply the PQ list
to an interface or PVC.
Configuring CQ: You can configure a CQ list that contains up to 16 queues. The CQ list
specifies the following information:
The queue where a packet is placed in.
The maximum length of each queue.
The number of bytes sent from the queue during a cycle of round robin scheduling.
Configuring RTPQ.
Configuring packet information pre-extraction: To process the original IP packets with QoS on
the physical interface for a tunnel interface, configure packet information pre-extraction on the
tunnel interface.
Command reference
See HPE FlexNetwork MSR Configuration Guides(V7) and HPE FlexNetwork MSR Command
References(V7).
To Next Page
Loading...
