120
Usage guidelines
You can specify multiple IKEv2 proposals for an IKEv2 policy. A proposal specified earlier has a
higher priority.
Examples
# Specify the IKEv2 proposal proposal1 for the IKEv2 policy policy1.
<Sysname> system-view
[Sysname] ikev2 policy policy1
[Sysname-ikev2-policy-policy1] proposal proposal1
Related commands
display ikev2 policy
ikev2 proposal
New command: reset ikev2 sa
Use reset ikev2 sa to delete IKEv2 SAs.
Syntax
reset ikev2 sa [ [ { local | remote } { ipv4-address | ipv6 ipv6-address } [ vpn-instance
vpn-instance-name ] ] | tunnel tunnel-id ] [ fast ]
Views
User view
Predefined user roles
network-admin
Parameters
local: Deletes IKEv2 SAs for a local IP address.
remote: Deletes IKEv2 SAs for a remote IP address.
ipv4-address: Specifies a local or remote IPv4 address.
ipv6 ipv6-address: Specifies a local or remote IPv6 address.
vpn-instance vpn-instance-name: Deletes IKEv2 SAs in an MPLS L3VPN instance. The
vpn-instance-name argument represents the VPN instance name, a case-sensitive string of 1 to 31
characters. If you do not specify a VPN instance, this command deletes IKEv2 SAs for the public
network.
tunnel tunnel-id: Deletes IKEv2 SAs for an IPsec tunnel. The tunnel-id argument specifies an IPsec
tunnel by its ID in the range of 1 to 2000000000.
fast: Notifies the peers of the deletion and deletes IKEv2 SAs directly before receiving the peers'
responses. If you do not specify this keyword, the device notifies the peers of the deletion and
deletes IKEv2 SAs after it receives the peers' responses.
To Next Page
Loading...
