HPE MSR3000 - New Feature: Support of Pppoe Server for Ipv6; Configuring Support of Pppoe Server for Ipv6; Command Reference; New Feature: QSIG Tunneling over SIP-T

231
New feature: Support of PPPoE server for IPv6
Configuring Support of PPPoE server for IPv6
On IPv6 networks, PPP negotiates only the IPv6 interface identifier instead of the IPv6 address and
IPv6 DNS server address during IPv6CP negotiation.
Command reference
See HPE FlexNetwork MSR Configuration Guides(V7) and HPE FlexNetwork MSR Command
References(V7).
New feature: QSIG tunneling over SIP-T
Configuring QSIG tunneling over SIP-T
QSIG tunneling over SIP-T tunnels QSIG messages across a SIP network by encapsulating them in
SIP message bodies. This feature enables ISDN networks to communicate over a SIP network.
Command reference
See HPE FlexNetwork MSR Configuration Guides(V7) and HPE FlexNetwork MSR Command
References(V7).
New feature: Playout delay
Configuring Playout delay
By buffering incoming voice packets with different delay times for a period of time (playout delay
time), the receiver can smoothly play out the voice packets to the codec. By configuring playout delay,
you can prevent delay variation (jitter) from affecting voice quality.
Command reference
See HPE FlexNetwork MSR Configuration Guides(V7) and HPE FlexNetwork MSR Command
References(V7).