21
List of resolved problems
Resolved problems in CMW710-R0306P30
201603140497
Symptom: An MSR2003 router displays the message "Watchdog timeout ==MSR2003 Reboot
with CW7 e0402l10" if GRE over IPsec runs on a subinterface and MPLS L3VPN settings are
configured on the GRE tunnel interface.
Condition: This symptom might occur if GRE over IPsec runs on a subinterface and MPLS
L3VPN settings are configured on the GRE tunnel interface.
201604200661
Symptom: When the full duplex mode is configured and the speed is set to 1000 Mbps for a
Layer 2 interface on an SIC-4GSW card, the interface cannot come up or uses an incorrect
duplex mode.
Condition: This symptom might occur if the full duplex mode is configured and the speed is set
to 1000 Mbps for a Layer 2 interface on an SIC-4GSW card.
201604280272
Symptom: On a China Telecom 3G interface, when the EVDO mode is enabled, an
hh3c3GRssiWeakSignalTrap notification for the CDMA-1x RTT mode is falsely generated.
When the CDMA-1x RTT mode is enabled, an hh3c3GRssiWeakSignalTrap notification for the
EVDO mode is falsely generated.
Condition: None.
201604220195
Symptom: Modem dialups fail on FXS, FXO, E&M, and BSV cards when modem pass-through
and fax pass-through are enabled.
Condition: This symptom might occur if modem pass-through and fax pass-through are
enabled.
201604220017
Symptom: When the receiving power and transmitting power of a transceiver module change,
the corresponding values in the MIB are not updated on time.
Condition: None.
201603140402
Symptom: The router provides 4G dialup services to an LTE network with two LNSs. When the
primary LNS fails, services are not switched to the standby LNS.
Condition: None.
201604260058
Symptom: The error packet suppression feature is removed.
Condition: None.
201605060432
Symptom: The format of POSA hello messages is incorrect, and the handshaking feature does
not take effect.
Condition: None.
To Next Page
Loading...
