222
New feature: VPLS
New feature: Multicast VPN support for inter-AS option B
Modified feature: 802.1X redirect URL
Modified feature: Displaying information about NTP servers from the reference source to the primary
NTP server
Modified feature: Saving, rolling back, and loading the configuration
Modified feature: Displaying information about SSH users
Removed feature: Displaying fabric utilization
New feature: Setting the RTC version
Configuring Setting the RTC version
The RTC protocol has the following versions: Version 3 and Version 5. Comware V3-based routers
support only Version 3. Comware V5- or Comware V7-based routers support both Version 3 and
Version 5.
To set the RTC version:
4. Enter system view.
system-view
N/A
5. Configure the RTC version.
rta rtc version
{
v3
|
v5
}
By default, the router uses
Version 5.
Command reference
rta rtc version
Use rta rtc version to set the RTC version.
Use undo rta rtc version to o restore the default.
Syntax
rta rtc version { v3 | v5 }
undo rta rtc version
Default
The router uses RTC Version 5.
To Next Page
Loading...
Need help?
General
