HPE MSR3000 - Command Reference; New Feature: Ipsec MIB and IKE MIB; New Feature: Poe; Configuring Poe

242
With MSDP peer relationships established between appropriate routers in the network, the RPs of
different PIM-SM domains are interconnected with one another. These MSDP peers exchange
source active (SA) messages, so that the multicast source information is shared among these
domains.
For more information about configuring MSDP, see "MSDP Configuration Guide" in HPE
FlexNetwork MSR Configuration Guides(V7).
Command reference
See HPE FlexNetwork MSR Command References(V7).
New feature: IPsec MIB and IKE MIB
IPsec-Monitor-MIB (HH3C-IPSEC-MONITOR-V2-MIB) monitors IPsec tunnels. NMS can use this
MIB to obtain IPsec tunnel information, including algorithms, gateway addresses, and tunnel
statistics. Except the trap function, all nodes of this MIB are read only.
Ike-Monitor-MIB (HH3C-IKE-MONITOR-MIB) monitors IKE tunnels. NMS can use this MIB to obtain
IKE tunnel information.
For more information, see the MIB companion document.
New feature: PoE
Configuring PoE
IEEE 802.3af-compliant power over Ethernet (PoE) enables a power sourcing equipment (PSE) to
supply power to powered devices (PDs) through Ethernet interfaces over twisted pair cables.
Examples of PDs include IP telephones, wireless APs, portable chargers, card readers, Web
cameras, and data collectors. A PD can also use a different power source from the PSE at the same
time for power redundancy.
For more information about configuring PoE, see "PoE Configuration Guide" in HPE FlexNetwork
MSR Configuration Guides(V7).
Command reference
See HPE FlexNetwork MSR Command References(V7).