EasyManua.ls Logo

HPE MSR3000 - Resolved Problems in CMW710-R0306 P12

HPE MSR3000
371 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
201605130382
•
Symptom: An incorrect PSTN cause code results in an incorrect SIP status code.
•
Condition: None.
201604290522
•
Symptom: Mirrored packets from a Layer 3 mirroring source port might carry an incorrect IP
version value.
•
Condition: None.
201603140262
•
Symptom: On an MSR4000 router, a GRE tunnel goes down because the router does not
receive GRE keepalive responses from the peer.
•
Condition: This symptom might occur if the router can receive GRE keepalive requests from the
peer, but no GRE keepalive responses are received.
201604090478
•
Symptom: On a voice VLAN-enabled Layer 2 port, MAC address entries of a non-voice VLAN
age out even when the port constantly receives traffic of the non-voice VLAN.
•
Condition: None.
201605260501
•
Symptom: After the debugging physical card e1posdm calling command is executed in
probe view, the undo form of the command does not take effect.
•
Condition: None.
201606060042
•
Symptom: A call is disconnected 30 seconds after a user places the call on hold.
•
Condition: This symptom occurs if the router does not send an RTCP message to the
Lync server within 30 seconds.
Resolved problems in CMW710-R0306P12
201602290360
•
Symptom: After a .cfg configuration file is used to restore the configuration of the router, OSPF
sessions that are not configured with a router ID do not use the global router ID.
•
Condition: This symptom might occur if a .cfg configuration file is used to restore the
configuration of the router.
201604010161
•
Symptom: MAC address entries age out on a voice VLAN-enabled Layer 2 interface when the
interface has been forwarding traffic to and from the corresponding MAC addresses.
•
Condition: This symptom might occur if voice VLAN is enabled on a Layer 2 interface.
201604130088
•
Symptom: On an MSR4000 router, interfaces remain in discarding state after spanning tree is
globally enabled.
•
Condition: This symptom might occur if spanning tree is globally enabled on an MSR4000
router.

Table of Contents