EasyManuals Logo

HPE MSR3000 User Manual

HPE MSR3000
371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
23
201605040142
•
Symptom: IKE SA setup fails because "Number of negotiating IKE SAs exceeded the limit" after
certain operations are performed.
•
Condition: This symptom might occur if the IKE keychain settings at the two ends of an IKE SA
are inconsistent and the IKE SA is repeatedly created and deleted.
201604260409
•
Symptom: IPv6 policy-based routing does not take effect.
•
Condition: None.
201604280185
•
Symptom: A device using non-standard protocols might drop the frames sent by the router
when the frames are VLAN-tagged and 64-byte long (including padding and CRC).
•
Condition: None.
201604260624
•
Symptom: After a port goes down, the FIB entry for a direct route that contains the port is
deleted after a delay of 20 seconds.
•
Condition: This symptom might occur if the router keeps forwarding traffic matching the direct
route.
201604180578
•
Symptom: The router does not process R2 B3 messages and forwards a wrong B message to a
PBX when receiving a SIP 410 message.
•
Condition: None.
201602180272
•
Symptom: An incorrect PSTN cause code is returned for an ISDN link down event.
•
Condition: None.
201605040146
•
Symptom: The undo mac-address dynamic mac-address vlan vlan-id command cannot
delete a dynamic MAC address entry.
•
Condition: None.
201603220579
•
Symptom: An MFR subinterface cannot forward traffic if the PVC is deleted at one end of the
link or the type of the PVC is modified from dynamic to static on the DTE.
•
Condition: This symptom might occur if the PVC of an MFR subinterface is deleted on one end
of the link or the type of the PVC is modified from dynamic to static on the DTE.
201605100011
•
Symptom: NetStream has incorrect outgoing traffic statistics for an interface if the interface
forwards traffic from an IP network to an MPLS network.
•
Condition: This symptom might occur if an interface forwards traffic from an IP network to an
MPLS network.
201605160128
•
Symptom: The router sends a wrong Release Cause code in a no pickup call.
•
Condition: None.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE MSR3000 and is the answer not in the manual?

HPE MSR3000 Specifications

General IconGeneral
BrandHPE
ModelMSR3000
CategoryNetwork Router
LanguageEnglish

Related product manuals