HPE MSR3000 User Manual

99
Using the Skip Current System Configuration option
1. Reboot the router to access the EXTEND-BOOTWARE menu, and then enter 6.
The current mode is password recovery.
Note: The current operating device is cfa0
Enter < Storage Device Operation > to select device.
===========================<EXTEND-BOOTWARE MENU>===========================
|<1> Boot System |
|<2> Enter Serial SubMenu |
|<3> Enter Ethernet SubMenu |
|<4> File Control |
|<5> Restore to Factory Default Configuration |
|<6> Skip Current System Configuration |
|<7> BootWare Operation Menu |
|<8> Skip Authentication for Console Login |
|<9> Storage Device Operation |
|<0> Reboot |
============================================================================
Ctrl+Z: Access EXTEND ASSISTANT MENU
Ctrl+F: Format File System
Enter your choice(0-9): 6
After the configuration skipping flag is set successfully, the following message appears:
Flag Set Success.
2. When the EXTEND-BOOTWARE menu appears again, enter 1 to reboot the router.
The router starts up with the factory-default configuration without deleting the next-startup
configuration files.
3. To use the configuration in a next-startup configuration file, load the file in system view.
<HPE> system-view
[HPE] configuration replace file cfa0:/startup.cfg
Current configuration will be lost, save current configuration? [Y/N]:n
Info: Now replacing the current configuration. Please wait...
Info: Succeeded in replacing current configuration with the file startup.cfg.
4. Configure a new console login authentication mode and a new console login password.
In the following example, the console login authentication mode is password and the
authentication password is 123456. For security purposes, the password is always saved in
ciphertext, whether you specify the simple or cipher keyword for the set authentication
password command.
<HPE> system-view
[HPE] line aux 0
[HPE-line-aux0] authentication-mode password
[HPE-line-aux0] set authentication password simple 123456
Use the line aux 0 command on an MSR2000 or MSR 3000 routers. The console port and the
AUX port are the same physical port.
Use the line console 0 command on an MSR4000 routers. An MSR4000 router has a separate
console port.
5. To make the settings take effect after a reboot, save the running configuration to the
next-startup configuration file.

HPE MSR3000 Specifications

General

Brand	HPE
Model	MSR3000
Category	Network Router
Language	English