HPE MSR3000 - New Feature: CFD Configuration; Configuring CFD Configuration

30
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number.
interface-name: Specifies an interface by its name.
Examples
# Display access control information for VA interfaces on VT interface 2.
<Sysname> display ppp access-control interface virtual-template 2
Interface: Virtual-Template2:0
User Name: mike
In-bound Policy: acl 3000
Totally 0 packets, 0 bytes, 0% permitted,
Totally 0 packets, 0 bytes, 0% denied.
Interface: Virtual-Template2:1
User Name: tim
In-bound Policy: acl 3001
Totally 0 packets, 0 bytes, 0% permitted,
Totally 0 packets, 0 bytes, 0% denied.
Table 1 Command output
Field Description
Interface VA interface that the PPP user accesses.
User Name Username of the PPP user.
In-bound Policy Security ACLs for the PPP user.
Totally x packets, x bytes, x% permitted
Total number, data rate, and pass percentage of permitted
packets.
Totally x packets, x bytes, x% denied Total number, data rate, and reject percentage of denied packets.
New feature: CFD configuration
Configuring CFD configuration
•
Configuring a two-way DM continuity test.
•
Setting the delay thresholds in a two-way DM continuity test.
•
Configuring a one-way packet loss continuity test.
•
Setting the packet loss ratio thresholds in a one-way packet loss continuity test.
•
Setting the time that a blocked port must wait before it comes up in a one-way packet loss
continuity test.
•
Configuring a bit error continuity test.