HPE MSR3000 User Manual

249
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
After you enable LDP IGP synchronization for IGP, for example, an OSPF area or an IS-IS process,
LDP IGP synchronization is enabled on the OSPF interfaces and IS-IS interfaces. To disable LDP
IGP synchronization on an interface, execute the mpls ldp igp sync disable command on that
interface.
Examples
# Enable LDP IGP synchronization on GigabitEthernet 0/1.
<Sysname> System-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] mpls ldp igp sync disable
Related commands
•
mpls ldp sync (IS-IS view)
•
mpls ldp sync (OSPF view/OSPF area view)
New feature: Enhanced routing features
Configuring enhanced routing features
This release supports RIB NSR, IPv4 static route FRR, direct route redistribution, and RFC4382 MIB
(MPLS-L3VPN-STD-MIB).
Command reference
non-stop-routing
Use non-stop-routing to enable RIB NSR to back up routing information.
Use undo non-stop-routing to restore the default.
Syntax
non-stop-routing
undo non-stop-routing
Default
RIB NSR is disabled.

HPE MSR3000 Specifications

General

Brand	HPE
Model	MSR3000
Category	Network Router
Language	English