EasyManua.ls Logo

HPE MSR3000 - Resolved Problems in CMW710-R0304 P12

HPE MSR3000
371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
42
Condition: This symptom might occur if OSPF is enabled on the router, and the router has been
operating for more than 210 days.
201507140154
Symptom: The router can be successfully logged in to by using a public key through SSH1, but
RSA fails to encrypt the public key.
Condition: This symptom might occur if a public key and SSH are used to log in to the router.
201508280355
Symptom: The HDLC process does not respond if the display interface serial command is
executed when the router receives ADDR_REQ packets.
Condition: This symptom might occur if the display interface serial command is executed
when the router receives ADDR_REQ packets.
201509220038
Symptom: The router fails TACACS authentication for an incorrect password or invalid shared
key if the TACACS server uses ACS V5.6 or later versions.
Condition: This symptom might occur if the TACACS server uses ACS V5.6 or later versions.
Resolved problems in CMW710-R0304P12
201507250134
Symptom: The router can be successfully logged in to by using an incorrect password.
Condition: This symptom might occur if remote TACACS authentication and NETCONF are
used to log in to the router.
201508030326
Symptom: An interface goes down and the router reboots unexpectedly if PPPoE sessions are
established on a large number of subinterfaces on the interface.
Condition: This symptom might occur if PPPoE sessions are established on a large number of
subinterfaces on the interface.
201508030334
Symptom: The secondary RADIUS authentication/authorization server cannot be reconfigured
if it has been deleted.
Condition: This symptom might occur if the secondary RADIUS authentication/authorization
server is deleted and then reconfigured.
201506190329
Symptom: An interface on an HMIM-8GSWF module cannot communicate with the directly
connected peer.
Condition: This symptom might occur if the port security mode of the interface is set to
autoLearn, and the HMIM module is rebooted.
201507300171
Symptom: The router reboots unexpectedly if the RADIUS server sends a DM request to log off
a user by session ID.
Condition: This symptom might occur if the RADIUS server sends a DM request to log off a user
by session ID.
201505200410
Symptom: Matching packets are not assigned to the RTP queue.

Table of Contents

Related product manuals