HPE MSR3000 - Page 45

41
201504130290
•
Symptom: Fax transmission fails if fax pass-through by using the G.711alaw or G711ulaw
codec is used for DIS signal transmission.
•
Condition: This symptom might occur if fax pass-through by using the G.711alaw or G711ulaw
codec is used for DIS signal transmission.
201509240046
•
Symptom: Some interfaces on the HMIM-8E1T1-F module cannot come up if the module is
produced on 11 August 2015 or after that date.
•
Condition: This symptom might occur if the HMIM-8E1T1-F module is produced on 11 August
2015 or after that date.
201508040165
•
Symptom: Some transactions of POS terminals fail if TCP FIN packets contain transaction data.
•
Condition: This symptom might occur if TCP FIN packets contain transaction data.
201507150251
•
Symptom: Layer 3 aggregate interfaces cannot be created by using IMC.
•
Condition: This symptom might occur if IMC is used to create Layer 3 aggregate interfaces.
201508290021
•
Symptom: The CPU usage is high if the TCP maximum segment size is set to 1400 bytes.
•
Condition: This symptom might occur if the following operations have been performed:
a. Use the tcp mss command to set the TCP maximum segment size to 1400 bytes.
b. Save the configuration and reboot the router.
201508250213
•
Symptom: The delay in the result of the NQA ICMP jitter operation is much larger than the delay
in the ping operation result.
•
Condition: This symptom might occur if the NQA ICMP jitter operation is performed.
201509140123
•
Symptom: The router cannot communicate with a Cisco device through the HDLC link between
them.
•
Condition: This symptom might occur if the ip address slarp interval 1 command is executed
on the Cisco device.
201508270343
•
Symptom: Tracert returns the destination IP address as the first hop if it is used on an L2TP
over IPsec tunnel.
•
Condition: This symptom might occur if tracert is used on an L2TP over IPsec tunnel.
201510130060
•
Symptom: The signature algorithm does not support HMAC-SHA256 when a certificate request
is made in non-FIPS mode.
•
Condition: This symptom might occur if the certificate request is made in non-FIPS mode.
201510200471
•
Symptom: The OSPF LSAs on the router do not age out. As a result, peers cannot learn routes
from the router.