28
201604130088
Symptom: When STP is globally enabled on a distributed router, the state of Layer 2 interfaces
becomes discarding.
Condition: None.
Resolved problems in CMW710-R0306P07
201601190330
Symptom: The VPM light of the RT-SPU-100 module fails the equipment test.
Condition: None.
201601200375
Symptom: The GPS track curve reported by the router is inaccurate.
Condition: This symptom occurs when the 4G modem just starts to work.
201601220079
Symptom: Repeated satellite information is displayed when you view the 4G modem
information.
Condition: None.
201512300275
Symptom: TACACS accounting configured at the CLI does not take effect.
Condition: This symptom occurs if the super command is used to obtain another user role.
201511270766
Symptom: The status of a Layer 2 aggregate interface is incorrect.
Condition: This symptom occurs if master/subordinate switchover is repeatedly performed for
the router.
201601080547
Symptom: The configuration of an Ethernet subinterface is lost after it is assigned to an
aggregation group.
Condition: This symptom occurs if the router reboots after the software is upgraded or the router
is started by using a .cfg configuration file.
201601120609
Symptom: The user profile name cannot contain periods (.).
Condition: None.
201601130385
Symptom: The router reboots unexpectedly.
Condition: This symptom occurs if LDP receives abnormal TCP PDUs with the length field value
0 in the header.
201601120436
Symptom: The CPU usage reaches 100% in the core where the LDP active process resides.
Condition: This symptom occurs if the following conditions exist:
LDP NSR is configured. After the session comes up, active/standby switchover has
occurred.
The number of messages that the session sends by using TCP is incorrectly counted.
To Next Page
Loading...
