EasyManuals Logo

HPE MSR3000 User Manual

HPE MSR3000
371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
51
201505190435
•
Symptom: Some BGP peers go down and come up after the router is rebooted.
•
Condition: This symptom might occur if the following conditions exist:
ï‚¡ The router is in an IRF fabric or is a distributed router in standalone mode.
ï‚¡ The router has a large number of BGP peers.
201507200270
•
Symptom: An MSR1000 router reboots repeatedly.
•
Condition: This symptom occurs if the following operations are performed:
a. Install a SIC-4SAE card into the router.
b. Send bidirectional traffic between the router and its peer device.
Resolved problems in CMW710-R0304P02
201505200131
•
Symptom: Voice services are interrupted during long calls.
•
Condition: This symptom might occur if E&M non-signaling mode and PCM pass-through are
enabled.
201506290040
•
Symptom: On a single-MPU router, the fan speed does not increase when the CPU
temperature keeps rising.
•
Condition: This symptom might occur if the router starts in high-temperature environments.
201505250288
•
Symptom: NQA TCP operations fail after the router runs for a period of time.
•
Condition: This symptom might occur if one of following conditions exists:
ï‚¡ The interval between NQA probes is shorter than 10 milliseconds.
ï‚¡ NQA operations are frequently performed over a long period of time.
201504230250
•
Symptom: The router displays garbled bandwidth usage-based load-sharing information for an
aggregate interface.
•
Condition: This symptom might occur if bandwidth usage-based load-sharing is enabled on the
aggregate interface.
201505250277
•
Symptom: OpenFlow cannot correctly send ARP packets to the SDN controller.
•
Condition: This symptom might occur if the following operations have been performed:
a. Save the running configuration and reboot the router.
b. Restore OpenFlow configuration by using an .mdb binary file.
201505150431
•
Symptom: 802.1X authentication fails.
•
Condition: This symptom might occur if the server issues VLAN IDs, but the length of the
Tunnel-Private-Group-id attribute is not 6 bytes in RADIUS packets sent by the server.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE MSR3000 and is the answer not in the manual?

HPE MSR3000 Specifications

General IconGeneral
BrandHPE
ModelMSR3000
CategoryNetwork Router
LanguageEnglish

Related product manuals