EasyManua.ls Logo

HPE MSR3000 - Page 54

HPE MSR3000
371 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
50
•
Condition: This symptom occurs if more than two VLANs exist and their VLAN interfaces are
assigned IP addresses.
201504230195
•
Symptom: On an IRF fabric, assertion information is displayed and subordinate routers reboot
when the IPv4 device is pinged from the IPv6 side.
•
Condition: This symptom occurs if the traffic processing unit for the AFT traffic of a VLAN
interface is not on the same forwarding card as the member interfaces of the VLAN interface.
201506090049
•
Symptom: The FCM card behaves unexpectedly.
•
Condition: This symptom occurs if FCM subinterfaces are deleted through MIB.
201507070310
•
Symptom: The link layer protocol of a DTE interface goes down.
•
Condition: This symptom occurs if the clock selection mode is set to autonegotiation for the
DTE interface.
201507010073
•
Symptom: The router reboots repeatedly after traffic statistics are cleared.
•
Condition: This symptom occurs if the following operations are performed:
a. Perform an active/standby switchover for HDLC interfaces that forward Layer 3 IP traffic.
b. Configure NetStream.
c. Enable the application statistics feature by using the application statistics enable
command.
201411030517
•
Symptom: Web redirection fails for a PPPoE user.
•
Condition: This symptom occurs if Web redirection parameters are assigned through RADIUS.
201503110069
•
Symptom: The VLAN ID sent to the RADIUS server is incorrect.
•
Condition: This symptom occurs if a QinQ PPPoE user comes online.
201503090276
•
Symptom: Users of a domain cannot be displayed or forcibly logged out.
•
Condition: This symptom occurs if the users come online without domain information.
201503110472
•
Symptom: Redirection fails after a PPPoE client issues a redirection attribute.
•
Condition: This symptom occurs if a PPPoE client issues a redirection attribute.
201503110566
•
Symptom: The redirection attribute issued through a COA message does not take effect.
•
Condition: This symptom occurs if the redirection attribute is issued through a COA message.
201507150201
•
Symptom: Assertion information appears when the pppoesd process is restarted on the L2TP
LNS.
•
Condition: This symptom occurs if a user comes online in NAS-initiated tunneling mode.

Table of Contents