EasyManuals Logo

HPE MSR3000 User Manual

HPE MSR3000
371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
49
201505250363
•
Symptom: Services are interrupted for about 50 minutes after the router runs for a long time
with traffic load.
•
Condition: This symptom might occur if the DH-Group2 algorithm is used in an IPsec VPN
environment.
201507200433
•
Symptom: An interface on an MSR2004 router is up, but does not receive packets.
•
Condition: This symptom occurs if the following conditions exist:
ï‚¡ The router runs for a long time with traffic load.
ï‚¡ The interface is configured with multiple features.
201506240472
•
Symptom: Of multiple EVI tunnels, only one tunnel can forward traffic.
•
Condition: This symptom occurs if the following conditions exist:
ï‚¡ The EVI tunnels have the same source IP address and the same destination IP address.
ï‚¡ Each EVI tunnel is used for a different VLAN.
201506030356
•
Symptom: The feature images are not selected from the storage medium where the current
boot and system images reside.
•
Condition: This symptom occurs if the router has multiple storage media.
201506230200
•
Symptom: The WAAS optimization effect is bad in per-flow load sharing mode.
•
Condition: None.
201507070433
•
Symptom: The peer port is up when the local fiber port is down.
•
Condition: This symptom occurs after the fiber port is changed from Layer 2 mode to Layer 3
mode.
201506250378
•
Symptom: An MSR3024 or MSR3044 router cannot forward 65-byte packets at wire speed
when fast forwarding is enabled.
•
Condition: This symptom occurs if fast forwarding is enabled.
201506020161
•
Symptom: BGP neighbors flap after the IRF fabric is restarted.
•
Condition: This symptom occurs if a large number of BGP neighbors are established
dynamically.
201507270061
•
Symptom: An aggregate interface with two or more member ports cannot ping the directly
connected interface.
•
Condition: This symptom occurs after the aggregate interface is changed between Layer 2
mode and Layer 3 mode more than 20 times.
201507090496
•
Symptom: The ARP packets of one VLAN interface are sent out of a member port of another
VLAN interface.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE MSR3000 and is the answer not in the manual?

HPE MSR3000 Specifications

General IconGeneral
BrandHPE
ModelMSR3000
CategoryNetwork Router
LanguageEnglish

Related product manuals