HPE MSR3000

158
source: Specifies a source IP address or source interface for IPv6 SSH packets. By default, the
device automatically selects a source address for IPv6 SSH packets in compliance with RFC 3484.
For successful IPv6 Stelnet connections, use one of the following methods:
•
Specify the loopback interface as the source interface.
•
Specify the IPv6 address of the loopback interface as the source IPv6 address.
interface interface-type interface-number: Specifies a source interface by its type and number. The
IPv6 address of this interface is the source IP address of the IPv6 SSH packets.
ipv6 ipv6-address: Specifies a source IPv6 address.
Usage guidelines
If the client and the server have negotiated to use certificate authentication, the client must verify the
server's certificate. For the client to correctly get the server's certificate, you must specify the server's
PKI domain on the client by using the server-pki-domain domain-name option. The client uses the
CA certificate stored in the specified PKI domain to verify the server's certificate and does not need to
save the server's public key before authentication. If you do not specify the server's PKI domain, the
client uses the PKI domain of its own certificate to verify the server's certificate.
The combination of an escape character and a dot (.) works as an escape sequence. This escape
sequence is typically used to quickly terminate an SSH connection when the server reboots or
malfunctions.
For the escape sequence to take effect, you must enter it at the very beginning of a line. If you have
entered other characters or performed operations in a line, enter the escape sequence in the next
line. HPE recommends that you use the default escape character (~). Do not use any character in
SSH usernames as the escape character.
Examples
# Use the 192-bit Suite B algorithms to establish a connection to the Stelnet sever 2000::1. Specify
the client's PKI domain and the server's PKI domain as clientpkidomain and serverpkidomain,
respectively.
<Sysname> ssh2 ipv6 2000::1 suite-b 192-bit pki-domain clientpkidomain server-pki-domain
serverpkidomain
New command: ssh2 suite-b
Use ssh2 suite-b to establish a connection to an IPv4 Stelnet server based on Suite B algorithms.
Syntax
ssh2 server [ port-number ] [ vpn-instance vpn-instance-name ] suite-b [ 128-bit | 192-bit ]
pki-domain domain-name [ server-pki-domain domain-name ] [ prefer-compress zlib ] [ dscp
dscp-value | escape character | source { interface interface-type interface-number | ip ip-address } ]
*
Views
User view