157
Parameters
server: Specifies a server by its IPv6 address or host name, a case-insensitive string of 1 to 253
characters.
port-number: Specifies the port number of the server, in the range 1 to 65535. The default is 22.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN instance to which the server belongs.
The vpn-instance-name argument represents the VPN instance name, a case-sensitive string of 1 to
31 characters.
-i interface-type interface-number: Specifies an output interface by its type and number for IPv6 SSH
packets. Specify this option when the server uses a link-local address to provide the Stelnet service
for the client. The specified output interface on the Stelnet client must have a link-local address.
suite-b: Specifies the Suite B algorithms. If neither the 128-bit keyword nor the 192-bit keyword is
specified, all algorithms in Suite B are used. For more information about the Suite B algorithms, see
Table 6.
128-bit: Specifies the 128-bit Suite B security level.
192-bit: Specifies the 192-bit Suite B security level.
pki-domain domain-name: Specifies the PKI domain of the client's certificate. The domain-name
argument represents the PKI domain name, a case-insensitive string of 1 to 31 characters, excluding
the characters listed in Table 10.
Table 10 Invalid characters for a PKI domain name
Tilde ~ Dot .
Asterisk * Left angle bracket <
Backslash \ Right angle bracket >
Vertical bar | Quotation marks "
Colon : Apostrophe '
server-pki-domain domain-name: Specifies the PKI domain for verifying the server's certificate.
The domain-name argument represents the PKI domain name, a case-insensitive string of 1 to 31
characters, excluding the characters listed in Table 10.
prefer-compress: Specifies the preferred compression algorithm for data compression between the
server and the client. By default, compression is not supported.
zlib: Specifies the compression algorithm zlib.
dscp dscp-value: Specifies the DSCP value in the IPv6 SSH packets. The value range for the
dscp-value argument is 0 to 63, and the default value is 48. The DSCP value determines the
transmission priority of the packet.
escape character: Specifies a case-sensitive escape character. By default, the escape character is a
tilde (~).
To Next Page
Loading...
Need help?
General
