C Disposal
HSD S.p.A. © - h0109k00a.fm120718
195
C Disposal
At the end of the product life cycle, it is the user's responsibility to dispose of it in the correct
manner.
First of all, clean the various parts and then separate them into mechanical and electrical
components.
The different materials, such as electric motors (copper windings), metal components, plastic
materials, lubricants, liquid coolants, etc. must be sorted and separated then disposed of in
accordance with the laws applicable in the country of installation.
The electrospindle contains a spring that has been pre-loaded with a force of
hundreds of kilos. This spring is applied to a screw dowel that can be violently
ejected if the electrospindle is dismantled by inadequately trained personnel.
Only carry out the operations described in this manual. Follow the instructions
scrupulously and in the case of doubt, contact the Manufacturer's Assistance
Service.
To Next Page
Loading...
