4 Transport, packing, unpacking, storage
92
HSD S.p.A. © - h0103k01a.fm120718
4.5 Storage
If the product is to be placed in storage, it must be stored with its original packing.
The packed product must be stored in a place that is protected from bad weather (rain, water,
humidity).
It is therefore necessary to:
carry out periodic checks to ascertain the general storage condition of the product;
manually rotate the electrospindle shaft approximately once a month to make sure that the
bearings remain perfectly greased.
Furthermore, it is necessary that during storage the following environmental conditions are
observed:
The maximum storage period, before the product must be controlled by the
manufacturer's authorised personnel is of 12 months.
For further information, contact Customer Service.
Storage temperature -5°C ÷ +55°C (23°F ÷ +131°F)
Non condensing relative humidity 5% ÷ 55%
To Next Page
Loading...
