To Next Page

To Previous Page

Configuring email notifications

Note: This procedure is optional.

To set up email notifications of library events:

1. In the Configure Library menu in the left navigation pane of the Web User Interface, click SMTP.

2. Configure the Send server settings.

v SMTP server address - SMTP mail server address. IPv4 and IPv6 addresses are supported. Host

names can be entered instead of numerical IP addresses if the DNS server is specified in the

Network settings.

v Sender address - Mail header information.

v Subject - Mail header information.

3. Enter the email addresses to be notified when an event takes place in the Mail To fields, and click the

Enable check boxes to select each address.

4. Select the event level to report in the Mail Event settings.

5. Click Test to send a test email message to the enabled addresses.

6. Click Submit to enable the settings.

Figure 99. Email notifications

94 IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572

IBM TS2900 User Manual

Other manuals for IBM TS2900