IBM TS2900 - Creating the Rail Assemblies

6. Install the rail assemblies into the rack (Figure 26 on page 32). Ensure the 3 holes in the front of the
unit align with the 1U space marked on the vertical rails in Step 2. Secure the rails to the rack with 4
flat-head screws ▌9▐ on each side of the rack. Use both of the two screw locations on the rear of the
rack rail (Figure 22 on page 29). Use the top and middle screw locations on the front of the rack rail
(Figure 21 on page 29).
a29z0018
7
Figure 25. Creating the rail assemblies
Installation and configuration 31