IBM TS2900 - Library Configuration with Cookies

number can be changed with the Web User Interface when logged in as service.
This procedure is used to replace the entire library in the event of a serious library malfunction.
1. If with a static IP address, make a note of your library's IP address. If with DHCP, proceed to the next
step.
2. Remove the old library chassis with the corresponding procedure in “Removing library from a rack”
on page 142 or “Removing library from a desktop” on page 147.
3. Install the new library chassis with the corresponding procedure in “Installing the library on a
desktop” on page 144 or “Installing the library in a rack” on page 149.
4. It is necessary to change the serial number on the new library to the serial number of the old library
to preserve your entitlement to IBM service.
v If you are with a static IP address, complete the following steps.
a. With the Operator Panel, enter the network settings for the library. See “Configuring network
settings” on page 71. Be sure to disable DHCP.
b. Log in to the Web User Interface as admin. The following screen displays.
Yes No
Yes No
Yes No
Yes No
Does AutoSaved
VPDDataexistforLibrary
IP Address?
DoesLibraryS/N=
AutoSavedS/N?
VPDData
isSaved
VPDData
isSaved
Write Auto
SavedVPDDatato
Library?
AutoSavedVPD
Dataiswritten
toLibrary
Overwrite Auto
SavedVPDData?
AutoSaved
VPDDatais
overwritten
AutoSaved
VPDDatais
notoverwritten
Figure 153. Library configuration with cookies
154 IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572