IBM TS2900 User Manual

– IPv6 - Select to enter four library IP addresses with the IPv6 protocol.
v Subnet Mask - If DHCP is disabled, set the IP address of the subnet mask.
– Subnet Mask - Select to enter the subnet mask address with the IPv4 protocol.
– Prefix Length - Select to enter the prefix length for the IPv6 protocol.
v Gateway - If DHCP is disabled, set the IP address of the gateway.
– IPv4 - Select to enter the gateway IP address with the IPv4 protocol.
– IPv6 - Select to enter four gateway IP addresses with the IPv6 protocol.
Configuring Operator Panel settings
Select Configuration > Configure Op Panel Settings to set the preferences when with the Operator
Panel.
Configure the Operator Panel with the following settings:
v Back light - Select to enable the LCD back light when with the Operator Panel.
– Input Count - If the auto back light is enabled, specify the time duration before the back light turns
OFF. The setting uses a four-digit timer in minutes.
v Login Password - Select to change the Operator Panel four-character login password. The new
password must be reentered for confirmation before the password is changed (default: 0000).
Configuring Web GUI Settings
Use Configuration > Configure Web GUI Settings > Unlock a User Account to unlock a User Account.
The password of the user unlocked by Unlock a User Account is automatically changed to secure.
Configuration
ConfigureOpPanelSettings
ConfigureLCDBackLight
Enable AutoBackLight
InputCount(min)
Disable AutoBackLight
ChangeLoginPassword
NewPassword
ReenterPassword
Figure 72. Operator Panel settings
a29z0206
Configuration
Configure WEB GUI Settings
Unlock a User Account
Figure 73. Configuring Web GUI settings
72 IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572

IBM TS2900 Specifications

General

Brand	IBM
Model	TS2900
Category	Storage
Language	English