Configuring trap notifications
Note: This procedure is optional. SNMP notifications are not enabled unless you have selected the SNMP
Enabled check box. To disable SNMP notifications, clear the SNMP Enable check box and click Submit.
The traps that are supported by the TS2900 Tape Autoloader are listed in “Trap definitions (types)” on
page 200.
To set up trap notifications for an SNMP server:
1. In the Configure Library menu in the left navigation pane of the Web User Interface, click SNMP
2. Select the SNMP Enabled check box.
3. Configure the SNMP server and header settings.
v Community - SNMP community name to which the library belongs.
v Name - Unique SNMP name for the system.
Figure 100. Trap notifications
Operations 95
|
|
|
|
|