9. Run the SAS cable, power cable, and Ethernet cable through the hook-and-loop fastener strap ▌12▐.
Leave enough slack to reach the corresponding connectors, then tighten the strap (Figure 29).
Note: For information about converting and relocating the library, see “Removal and replacement
procedures” on page 141.
Removing the accessor locking screw
Important: The accessor locking screw prevents the library accessor from moving during shipment and
must be removed before the library is powered ON.
Remove the accessor locking screw, located on the rear panel of the library (▌1▐ in Figure 30 on page 34).
Figure 28. Securing the rear of the library in the rack
Figure 29. The cables at the rear of the library
Installation and configuration 33
To Next Page
Loading...
