12. Remove the flat-head screws ▌6▐ on each side to remove the left ▌5▐ and right ▌3▐ rails from the
chassis (Figure 144)
Installing the library in a rack
For details on the rack mount kit components, see “Installing in a rack” on page 26.
1. Determine the location in your rack for your library and mark with a pencil. For details on rack
mount locations, see “Installing in a rack” on page 26.
2. Attach the left ▌3▐ and right ▌4▐ front brackets to the front of the library chassis with 2 flat-head
screws ▌8▐ on each side (Figure 145 on page 150). Use the bottom two screw holes on each side.
Figure 143. Removing the feet
Figure 144. Removing side rails from the library chassis
Removal and replacement procedures 149
To Next Page
Loading...
