Configuring the library
The library can be configured with the Web User Interface or the Operator Panel. The preferred method
for configuring your library is by using the Web User Interface. See “Configuring your library with the
Operator Panel” on page 54 and “Configuring your library with the Web User Interface” on page 37.
For complete detailed information about all of the functions available on the library with the Operator
Panel and the Web User Interface, see “Operations” on page 61.
The default library configuration settings are listed in Table 16.
Table 16. Default library configuration settings
Configuration Item Default Setting
NETWORK
Ethernet link speed Auto
SSL security Disabled
IPv4 settings Enabled
DHCP (Dynamic Host Configuration Protocol) Enabled
Static IP address Disabled
IPv4 address 0.0.0.0
Subnet mask 255.255.255.0
Gateway 0.0.0.0
IPv6 settings Disabled
DHCP (Dynamic Host Configuration Protocol) Enabled
Stateless auto-configuration Enabled
Static IP address Disabled
IPv6 address 0:0:0:0:0:0:0:0
Prefix length 64
Gateway 0:0:0:0:0:0:0:0
DNS setting Disabled
DNS IP address 0.0.0.0
PHYSICAL
Library name (Blank)
Auto Cleaning Disabled
Bar code label length 8 characters
LOGICAL
Library mode Random
Loop Enabled
Auto Load Enabled
Active slots 9 + 0
ENCRYPTION (S4H and LATER ONLY)
Encryption method None
Encryption policy Encrypt All
SSL security Disabled
Primary EKM server address 0.0.0.0
36 IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
To Next Page
Loading...
Need help?
General