To modify the encryption settings:
1. In the Configure Library menu in the left navigation pane of the Web User Interface, click Encryption
2. Enter the Feature Activation Key (see Figure 38 on page 44) and click Submit to enable encryption in
your library.
3. Select the Security settings.
v Enable SSL for EKM - Select to enable secure communications between the tape library and the
EKM server.
4. Select the Encryption method settings.
v Application Managed Encryption - For encryption in operating environments that run an
application capable of generating and managing encryption policies and keys. If you select
application-managed encryption, no further configuration steps are necessary.
v System Managed Encryption - For encryption in operating environments where no application is
capable of key management runs, and encryption is set up implicitly through each instance of the
IBM device driver.
v Library Managed Encryption - For transparent encryption by the TS2900 Tape Autoloader tape
drive.
Figure 39. Encryption enabled settings
Installation and configuration 45
|
|
|
|
|
To Next Page
Loading...
Need help?
General