8. Insert and tighten the accessor locking screw ▌1▐.
9. Remove the SAS cable, power cable, and Ethernet cable from the hook-and-loop fastener strap ▌12▐
on the rear of the library (Figure 131).
10. Remove the 2 round-head screws ▌10▐ on each rear bracket that are securing the rear of the library
to the rack (Figure 132).
11. Remove the large black screws ▌11▐ from each front bracket that is securing the front of the library
to the rack, and slide the library chassis out of the rack (Figure 133 on page 144).
Figure 130. Insert accessor locking screw
Figure 131. Removing cables at the rear of the library
Figure 132. Removing screws at the rear of the library
Removal and replacement procedures 143
To Next Page
Loading...
