7. Slide the library chassis into the rack. Secure the front of the library to the rack with the large black
screws ▌11▐ in the bottom holes on each front bracket (Figure 27).
8. Secure the rear of the library to the rack with a round-head screw ▌10▐ on each rear bracket (Figure 28
on page 33). Tighten the other rear bracket screws to secure the library to the rack.
Figure 26. Installing the rail assemblies
Figure 27. Securing the front of the library in the rack
32 IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
To Next Page
Loading...
