IBM TS2900 - Page 215

Table 32. Library error codes (continued)
Code (H) Description Panel Indication Action Required
002B
Commands to the encryption
capable drive over the retry limit.
-
1. Reseat all cables. See “Reseating cables” on
page 137.
2. Cycle the power supply and try again.
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see “Contacting
IBM technical support” on page 139.
002C
LDI I/F error.
ACK IU event timeout detected.
-
Cycle the power supply and try again.
v If the problem is corrected, run Library Verify
before normal library operations resume.
v If the problem persists, see “Contacting IBM
technical support” on page 139.
002D
LDI I/F error.
Response IU event timeout
detected.
-
002E
LDI I/F error.
Transfer Ready IU event timeout
detected.
-
002F
LDI I/F error.
Undefined error detected.
-
0040
A drive media error detected
upon insertion.
CHK 0040
1. Verify that the cartridge is compatible with
the drive in your library. See “Cartridge
compatibility” on page 109.
2. Verify that the cartridge is not
write-protected. See “Write-Protect switch”
on page 114.
3. If it is a cleaning cartridge, verify that the
cartridge is not expired. See “Cleaning
cartridge” on page 111.
4. Cycle the power supply and try again.
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see “Contacting
IBM technical support” on page 139.
0041
A hardware error detected upon
media insertion
CHK 0041
0042
A drive load timeout error
detected upon insertion.
CHK 0042
Cycle the power supply and try again.
v If the problem is corrected, run Library Verify
before normal library operations resume.
v If the problem persists, see “Contacting IBM
technical support” on page 139.
0048 Incompatible medium installed. CHK 0048
Verify that the cartridge is compatible with the
drive installed in the library. See “Cartridge
compatibility” on page 109.
v If the problem is corrected, run Library Verify
before normal library operations resume.
v If the problem persists, see “Contacting IBM
technical support” on page 139.
Appendix B. Error codes 189