EasyManuals Logo
Home>IBM>Storage>TS2900

IBM TS2900 User Manual

IBM TS2900
286 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #218 background imageLoading...
Page #218 background image
Table 32. Library error codes (continued)
Code (H) Description Panel Indication Action Required
0080
X movement error #1.
During X movement, the target
stop position's origin sensor error
detected. Suspect the X origin
sensor or X motor.
CHK 0080
1. Check the accessor locking screw and
remove it if it is installed. See “Removing the
accessor locking screw” on page 33.
2. Cycle the power supply and try again.
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see “Contacting
IBM technical support” on page 139.
0081
X movement error #2.
During X movement, a motor
sync error detected. Suspect the X
encoder sensor or X motor.
CHK 0081
0082
X movement error #3.
During initialization, a motor sync
error detected. Suspect the X
encoder sensor or X motor.
CHK 0082
0083
During an eject operation or move
operation (to a storage position),
the X origin sensor could not be
detected. Suspect the X origin
sensor or X motor.
CHK 0083
0084
During initialization, the X origin
position could not be detected.
Suspect the X origin sensor or X
motor.
CHK 0084
0088
X calibration error #1.
During X calibration, centering
sensor OFF condition could not be
detected.
CHK 0088
0089
X calibration error #2.
During X calibration, centering
sensor ON condition could not be
detected.
CHK 0089
008F
During X operation, the cartridge
magazine was removed. Suspect
the magazine set sensor.
CHK 008F
1. Confirm that the magazine is closed.
2. Cycle the power supply and try again.
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see “Contacting
IBM technical support” on page 139.
00B0
Failed to detect media in the
accessor at completion of GET
operation. Suspect the centering
sensor, X motor, or P motor.
CHK 00B0
1. Confirm the media is compatible.
2. Cycle the power supply and try again.
v If the problem is corrected, run Library
Verify before normal library operations
resume.
v If the problem persists, see “Contacting
IBM technical support” on page 139.
192 IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572

Table of Contents

Other manuals for IBM TS2900

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM TS2900 and is the answer not in the manual?

IBM TS2900 Specifications

General IconGeneral
BrandIBM
ModelTS2900
CategoryStorage
LanguageEnglish

Related product manuals