Table 15. Rack mount assembly kit (continued)
Number Part Number Quantity Description Part
▌11▐ 45E3867 2
Screw,
cross-recessed pan
head, M6x10
▌12▐ 07H6655 1
Hook-and-loop
fastener strap
▌13▐ 39M5378 1
Rack device to
PDU power cord
When you decide on a location in your rack for the library, consider that the Operator Panel has a small
LCD screen. The library must be positioned to allow for easy viewing. The rear of the library must be
free from any obstructions to allow easy access to the power switch and other rear panel components.
Note: Before you begin the rack installation of the library, read the safety information in “Rack safety” on
page xix. Also, verify that no desktop feet are attached to the bottom of the library.
To install the library in a rack:
1. Verify that your rack kit includes all the necessary contents. See Table 15 on page 26.
2. Determine the location in your rack for your library to be installed. With a pencil, mark the location
on the front vertical rails (Figure 21 on page 29) and rear vertical rails (Figure 22 on page 29) in your
rack.
28 IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572
To Next Page
Loading...
