IBM TS2900 User Manual

v Location - Physical location of the system.
v Contact - Contact person's name.
v SNMPv3 engine ID - A read-only attribute that identifies the SNMPv3 engine.
4. Enter the settings of the SNMP monitoring stations to be notified when an event takes place by
clicking the modify buttons in the Trap List box.
v Validity - Select the check box to enable and clear the check box to disable.
v Address - IPv4 and IPv6 addresses are supported. Host names can be entered instead of numerical
IP addresses if the DNS server is specified.
v Version - Trap version v1, v2c, or v3. For v2c and v3, the Inform check box determines if an SNMP
INFORM request is sent instead of a trap event.
v Community (v1 or v2c) - SNMP community name.
v User name (v3 only) - SNMPv3 unique user name.
v Authentication (v3 only) - Authentication algorithm: disable, MD5, or SHA.
v Authentication Password - When an Authentication algorithm is enabled, an Authentication
Password is required. (see “Configuring Password Rules Settings” on page 52).
v Confirm - Re-enter the Authentication Password to confirm it.
v Privacy (v3 only) - Privacy service encryption and decryption algorithm: disable, DES, or AES.
When an algorithm is specified, a privacy password is required.
v Privacy password - enter a password (see “Configuring Password Rules Settings” on page 52).
v Confirm - Re-enter the Privacy password to confirm it.
5. Click Submit to save the SNMP Trap settings. Modify each trap's settings by repeating the previous
step.
6. Enter the SNMPv3 users who are allowed to access the tape library by clicking the modify buttons in
the SNMPv3 User List box.
Figure 42. SNMP trap settings
Installation and configuration 49
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|

IBM TS2900 Specifications

General

Brand	IBM
Model	TS2900
Category	Storage
Language	English