Programming IDEC SmartRelay
3.8 Configuring additional functions for IDEC SmartRelay
IDEC SmartRelay Manual
104
Diagnosing a specific IP address
ou can check the availability of a specific IP address by following these steps:
1. In the diagnostics menu shown below, move the cursor to
: Press or
2. Confirm : Press O
3. Move the cursor to
: Press or
4. Confirm
: Press O. IDEC SmartRelay displays the following view:
5. To enter an IP address, Press O
. hen the cursor appears in a flashing solid suare,
press or to move the cursor to a position where you want to modify the number, then
press or to increase or decrease the number.
6. Press O
to confirm your input.
hen pinging the IP address is successful and the IP address is available, O message is
displayed. If timeout occurs and the IP address is unavailable, an error message is
displayed.
IDEC SmartRelay stores up to four addresses that you entered previously. To view your
last inputs, press to move the cursor to the symbol, and then press O
to open a
drop-down list, for example:
ou can press or to select a previously configured address in the list, and then press
O
to comfirm.
+DUGZDUH
To Next Page
Loading...
Need help?
General
