UDF (User-Defined Function)
IDEC SmartRelay Manual
248
6. Move the cursor to U1: Press , , or .
7. Press O to enter the screen form for the first UDF block U1. To select another element,
press the curor keys.
8. Position the cursor on the selected input (I1 in this example) and press O
. The cursor
appears in a flashing solid suare. If you want to change the first input to another element,
press or .
9. Confirm your selection by pressing O
. The first input of U1 is now changed.
E
diting elements to the outputs of a UDF block
If IDEC SmartRelay shows the following screen form as shown in the above Step 5 and you
want to change 1 to another element, follow the steps below:
1. Press O
and IDEC SmartRelay shows the following display:
2. Move the cursor to In by pressing . Press O
and the cursor appears in a flashing solid
suare. ou can change the input to U1.1 (.1 refers to the first output of the UDF block
that is connected to 1) by pressing or and IDEC SmartRelay shows the following
display:
8
8
,
$,
,
4
$4
4
3DU
8
8
0
$,
,
4
$4
4
3DU
1(:
8
4
,
$,
,
4
$4
4
4
,Q
4
4
8
To Next Page
Loading...
