UDF (User-Defined Function)
IDEC SmartRelay Manual
250
Setting the Par parameter
ou can edit the Par parameter for your UDF block if you have configured parameters for this
UDF using indLGC otherwise, you cannot edit parameters for UDF blocks. If your UDF
block contains the P
ar parameter, you can edit the parameters as described below:
View in programming mode (example):
1. Press to move the cursor to Par and press O
. IDEC SmartRelay shows you the
following display (T and TH are the identifiers you specified for the relevant UDF
parameters in indLGC. ou can configure a maximum of eight parameters for each UDF
block using indLGC. IDEC SmartRelay can show a maximum of three parameters on a
single display.):
2. Press O
and the cursor moves to the first number of T:
3. Press or to change the value. Press or to select another number and then press
or to change its value. Press O
to confirm your modifications. Then IDEC SmartRelay
shows the following display:
ou can also edit UDF parameter settings in parameter assignment mode in the same way as
you do in programming mode.
8
8
,
$,
,
4
$4
4
3DU
)LUVWYLHZRI8SDUDPHWHUV
8KDVRQHYLHZRISDUDPHWHUVLQWRWDO
7
7+
8
V
V
7
7+
8
V
V
7
7+
8
V
V
To Next Page
Loading...
