IDEC SmartRelay Manual
71
Programming IDEC SmartRelay
3.7 riting and starting the circuit program
4. Confirm : Press O
5. Press or to move up and down the alphabet to select your letters. Because Base
Module only provides uppercase letters for the password, you can uickly access letters
at the end of the alphabet (in this example, English) by using the button:
Press once to select
Press twice to select
, etc.
The display appears as follows:
To enter a password of AA, for example, the procedure is the same as for entering the
name of the circuit program.
6. Select A
: Press
7. Move to the next letter: Press
8. Select A
: Press
The display now appears as follows:
9. Confirm the password: Press O
ou have now protected your circuit program with the password AA and IDEC SmartRelay
returns to the programming menu.
Note
ou can cancel the input of a new password with ESC. In this case, Base Module returns to
the programming menu without saving the password.
ou can also set your password using indLGC or Text Display. ou cannot edit a
password-protected circuit program in a Base Module or upload it to indLGC unless you
enter the correct password.
To allow you to create and edit a circuit program for a protected module (Card), you first need
to Program copy protection (Page 275).
1HZ3DVVZRUG
1HZ3DVVZRUG
$$
To Next Page
Loading...
Need help?
General
